[ Previous  |  Next ]     [ Up  |  First  |  Last ]     (Article 257 of 310)
 
 
Parts Inspection and Digitizing Commands
PROBE1
 
PROBE1 can be used with any axis move to command an interrupted move. The
move will be terminated when an input goes low.
Example:  PROBE1 F.01 X1.3 Y-2
 
The X and Y move toward 1.3 and -2 respectively until the probe contacts the part.
PROBE2
 
PROBE2 may be used with any axis move to command an interrupted move.
The move will be terminated when an input goes high.
Example:  PROBE2 F.01 X1.3 Y-2
 
The X and Y move toward 1.3 and -2 respectively until the probe releases from the part.
 
Note:   The input used by the probe commands is selectable in the miscellaneous parameters.